Rope cutter YH-9F

The blade is mounted at the front, the operator can hold the cutting material effortlessly, this design make operator more comfo

 Preparation  

A. Loosen the knurled nut when device is cold,

insert each leg of the blade and tighten the knurled 

nuts, make sure that the blade and cutting head

have optimal contact.

B. Power on.

Cutting  

A. Avoid direct short circuit between cutting heads.

B. switch on the hot knife to “ON”

C. Adjust the temperature from low to high range, one  

can have a try on the small piece of foam  

D. Close to the blade, and press a bit, the rope will be cut.

E. Clean the blade by brush.

Caution

A. Always operate the Hot Knife in well ventilated space  

B. Never burn off excess residue on the hot knife blade. The blades will overheat, warping the blade.

C. DO NOT heat the blade when not operating, otherwise, the blade may warp.

D. Allow blades to cool before handling. A hot blade may cause injury or burns to exposed surfaces

Specification:

Model	YH-9F
Voltage	AC230V/50Hz
Weight	1.5Kg
Power	MAX.60W
Temp. of blade	Up to 500°C in seconds
Power cord length	2.5M
Size	20/11/9cm

Rope cutter YH-9F